Easyscriber engrave attachment for Hypertherm torch's

Torchmate older driver software question.

Post your questions or tips on Torchmates software in this topic.
Post Reply
Posts: 7
Joined: Sun Feb 14, 2016 11:38 am

Torchmate older driver software question.

Post by Kitch940 » Sun Feb 19, 2017 12:44 pm

Hello all I am currently running an old TM 1 table with version 5 cad and 1.6 driver software. Talked to TM tech support about upgrading software with my 401a signal generator. One guy told me some can be upgraded to version 2 and some can not. Another guy told me none can because they are not usb type generators like the 501a. On the website it says if you are running a 401a signal generator and version 1 software, version 2 software may be a purchased upgrade. Not sure what to believe but I would like to find out the correct answer here. TM support wants to sell me a 501a generator and version 4 software for 2 grand of course. Not worth it to me. Any old school guys out there have an answer for me?


TM 1 4x8 with Hypertherm Powermax 800

Post Reply

Return to “Torchmate Software”