Timing out

Torchmates software related questions and tips can be posted here
Post Reply
iron2
2 Star Member
2 Star Member
Posts: 62
Joined: Fri Oct 31, 2014 2:04 pm

Timing out

Post by iron2 »

I am getting a time out on controller to PC. Running windows 7. Upon start of cut it will run for a bit then time out. The torch will keep firing until I shut the plasma machine off. At that point I shut off the controller and back on to reset but then the table still won't respond.
I have gone to settings and disabled the USB conserve and set the computer to performance. I also put on a new usb cable from the PC to controller. Any ideas out there?
Homebuilt 2x4 water table
Torchmatecad
Flashcut THC
Hypotherm 45
iron2
2 Star Member
2 Star Member
Posts: 62
Joined: Fri Oct 31, 2014 2:04 pm

Re: Timing out

Post by iron2 »

Got it figured out separated usb cable and others and all is well,so far.
Homebuilt 2x4 water table
Torchmatecad
Flashcut THC
Hypotherm 45
iron2
2 Star Member
2 Star Member
Posts: 62
Joined: Fri Oct 31, 2014 2:04 pm

Re: Timing out

Post by iron2 »

Spoke too soon :(
Homebuilt 2x4 water table
Torchmatecad
Flashcut THC
Hypotherm 45
gs123
2.5 Star Elite Contributing Member
2.5 Star Elite Contributing Member
Posts: 149
Joined: Tue Apr 17, 2012 3:48 pm
Location: S/W Louisiana

Re: Timing out

Post by gs123 »

good job figuring it out.
Post Reply

Return to “Torchmate Software”