RhinoCAM on a plasma table

EverydayDiesel · Post by **EverydayDiesel** » Tue Dec 08, 2020 12:07 am

Hello,

Is anyone out there using RhinoCAM for their plasma table? I am getting comfortable with Rhino3D and need a post processor. Will it do kerf compensation? Has anyone used RhinoCAM for this successfully?

Thanks in advance for any help you can give

Post by **acourtjester** » Tue Dec 08, 2020 9:29 am

Les from SheetCam has helped other in the past, if you find one of his posts then look to the right and under his name click on the icon. This will bring up another small icon click on that to send him a private message from here.

: les.JPG (19.59 KiB) Viewed 344 times

EverydayDiesel · Post by **EverydayDiesel** » Tue Dec 08, 2020 10:02 am

Is sheetcam related to rhinocam?

RhinoCAM on a plasma table

RhinoCAM on a plasma table

Re: RhinoCAM on a plasma table

Re: RhinoCAM on a plasma table