Rhino CAD Drawing

General software related questions should be posted here.
Post Reply
Arctechwelding
1/2 Star Member
1/2 Star Member
Posts: 9
Joined: Sun May 21, 2017 8:25 pm

Rhino CAD Drawing

Post by Arctechwelding »

I am new to using the Rhino CAD program and am in the middle of trying to draw an Octagon Fire Pit. I am not able to get all my panel, or side equal it turns out 4 side one length, the other 4 smaller length. The measurements are 49" area x 23" height. I had it pretty close but not sure where i'm going wront on the drawing. Any suggestions welcome, ive tried making i an even number with the same issue.
User avatar
djreiswig
4.5 Star Elite Contributing Member
4.5 Star Elite Contributing Member
Posts: 1929
Joined: Thu Nov 19, 2015 10:02 pm
Location: SE Nebraska

Re: Rhino CAD Drawing

Post by djreiswig »

2014 Bulltear (StarLab) 4x8
C&CNC EtherCut
Mach3, SheetCam, Draftsight
Hypertherm PM65
Oxy/Acetylene Flame Torch
Pneumatic Plate Marker, Ohmic, 10 inch Rotary Chuck (in progress)
Post Reply

Return to “General Discussion”