Extra contour/Viewport? from draftsight

General software related questions should be posted here.
Post Reply
859Design
1/2 Star Member
1/2 Star Member
Posts: 9
Joined: Thu Jan 10, 2019 7:08 pm

Extra contour/Viewport? from draftsight

Post by 859Design »

I get an extra rectangle when opening a drawing from Draftsight in Sheetcam. It's not a SC issue, it is related to something in draftsight I think they call viewports.
How to you stop them from being exported with your design? They do not show up while creating a part. It throws off the origin in Sc and you have to move the parts around to get them where they should of already been.
Just extra steps that are not needed if I could find the right setting to change.
Pic included. Just a sample to show how it adds the rectangle around the center design.
Attachments
New Image.jpg
Post Reply

Return to “General Discussion”