It is currently Mon Nov 12, 2018 1:07 pm


machine not responding to offset

General software related questions should be posted here.
Posts: 3
Joined: Tue May 08, 2018 8:07 pm

machine not responding to offset

Postby falcondan » Fri Jun 01, 2018 8:45 pm

Hello to the group. Brand new member here and I have been reading a lot and have already been IMPRESSED by what is available here. My Uncle just purchased a Plasmacam DNC 2. Everything is going pretty good but when we try to cut the 1" square to set the X/Y offset, the machine doesn't seem to respond. We keep getting .976" squares. Like 7 of them already! I have tried to change the offset from -0.020 al the way to .1 and we just keep getting .976" squares. (wish there was a market for them!!) Am I missing a command to accept changes, or something else?
Thanks in advance for any ideas!!!
Thank you for this wonderful forum!!

Return to “General Discussion”

Who is online

Users browsing this forum: No registered users and 3 guests

Easyscriber engrave attachment for Hypertherm torch's