Hello, help required.
-
- 1/2 Star Member
- Posts: 8
- Joined: Wed Oct 26, 2016 1:31 pm
Hello, help required.
Hi Guys.
I am a newbie.
I am using emachineshop to draw some panels for a firepit, but sheetcam doesnt like the file. Can you see anything obviously wrong with the file??
Thanks
- acourtjester
- 6 Star Elite Contributing Member
- Posts: 7794
- Joined: Sat Jun 02, 2012 6:04 pm
- Location: Pensacola, Fla
Re: Hello, help required.
Hi
I opened it in Inkscape and combined all segments of the drawing and it opened fine in SheetCam about 9" wide.
Yours opened fine in SheetCam too but it was very large and the node count was low.
I opened it in Inkscape and combined all segments of the drawing and it opened fine in SheetCam about 9" wide.
Yours opened fine in SheetCam too but it was very large and the node count was low.
DIY 4X4 Plasma/Router Table
Hypertherm PM65 Machine Torch
Drag Knife and Scribe
Miller Mig welder
13" metal lathe
Small Mill
Everlast PowerTig 255 EXT
Hypertherm PM65 Machine Torch
Drag Knife and Scribe
Miller Mig welder
13" metal lathe
Small Mill
Everlast PowerTig 255 EXT
-
- 1/2 Star Member
- Posts: 8
- Joined: Wed Oct 26, 2016 1:31 pm
Re: Hello, help required.
I found a fix by clicking on 3D tab in emachineshop, it highlights problem and offers 'auto fix' ' which I selected, it then worked fine. Have just cut out my first part.
Thanks for your reply, sure I will have plenty of more newbie questions to follow.
Cheers
Thanks for your reply, sure I will have plenty of more newbie questions to follow.
Cheers