Money, how much to charge.

General software related questions should be posted here.
Post Reply
rocksolidframes
1 Star Member
1 Star Member
Posts: 19
Joined: Sun May 17, 2009 6:20 pm

Money, how much to charge.

Post by rocksolidframes »

Does anyone have a system for billing? My drawing program will provide the actual inches of cutting, this is accurate information as to what work has been done. What should I times this number by, not including the material cost? Someone once posted "How To Be Successfull At This Business", I wish I had read what he had to say, did any of you guys read it?

Thanks, Saddlebur
mdwalker
3.5 Star Elite Contributing Member
3.5 Star Elite Contributing Member
Posts: 524
Joined: Fri Nov 14, 2008 10:20 am

Re: Money, how much to charge.

Post by mdwalker »

Check out this post. I will try to repost the file if you can't find it.
http://www.plasmaspider.com/viewtopic.php?f=45&t=637

Danny
Danny Walker
Walker Manufacturing
Tishomingo, Oklahoma USA
www.walkermfg.net
rocksolidframes
1 Star Member
1 Star Member
Posts: 19
Joined: Sun May 17, 2009 6:20 pm

Re: Money, how much to charge.

Post by rocksolidframes »

Thanks mdwalker for your response,
I checked out your post, it was very inlightening, it doesn't take a genious to figure out that may be I should just go fishing too.

Saddlebur
Post Reply

Return to “General Discussion”