Hello to the group. Brand new member here and I have been reading a lot and have already been IMPRESSED by what is available here. My Uncle just purchased a Plasmacam DNC 2. Everything is going pretty good but when we try to cut the 1" square to set the X/Y offset, the machine doesn't seem to respond. We keep getting .976" squares. Like 7 of them already! I have tried to change the offset from -0.020 al the way to .1 and we just keep getting .976" squares. (wish there was a market for them!!) Am I missing a command to accept changes, or something else?
Thanks in advance for any ideas!!!
Thank you for this wonderful forum!!
It is currently Sun Oct 21, 2018 10:55 am
General software related questions should be posted here.
1 post • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 4 guests