Page 1 of 1

coreldraw ? after drawing

Posted: Mon Jan 08, 2018 11:11 pm
by plasmachad
I used to have a plasmaroutecnc table and steve put a shortcut on my toolbar that I used when I got done drawing I would click on this. Does anyone know what the shortcut was or what the symbol was? I can't remember because it's been over 5 years since I had that table, and I am just getting back into it. I think it was something to do with DXF conversion. Can anyone help me out? Thanks

Re: coreldraw ? after drawing

Posted: Mon Jan 08, 2018 11:57 pm
by tirediron
I can tell you tomorrow as the computer in my shop has this feature. I also have the plasmaroute table. It will give a dxf file that you can use in sheetcam -

Gerry

Re: coreldraw ? after drawing

Posted: Tue Jan 09, 2018 9:19 pm
by Largemouthlou
dxftool.. Google that

Re: coreldraw ? after drawing

Posted: Thu Jan 11, 2018 8:24 pm
by plasmachad
Thanks guys I got it