Corel closes open paths when saving as dxf

Corel Draw Graphics Suite related questions and tips can be posted here
Post Reply
User avatar
Sampson Jones
3 Star Elite Contributing Member
3 Star Elite Contributing Member
Posts: 333
Joined: Mon Jul 25, 2011 9:30 pm

Corel closes open paths when saving as dxf

Post by Sampson Jones »

Long time corel usesr . Weirdness happening now , when I do a save as crd drawing to dxf , when I open the new dxf open paths are closed . When I save as a cdr drawing that was grouped to dxf , when I open that the open paths are missing ? WTF ?
My design , 4ft x 8 ft water table
CandCNC electronics
Hypertherm powermax 65
Command Lineux
Super z 2
Sheetcam
Inkscape and corel draw
weldguy
4 Star Elite Contributing Member
4 Star Elite Contributing Member
Posts: 1901
Joined: Fri Apr 17, 2009 11:48 am

Re: Corel closes open paths when saving as dxf

Post by weldguy »

That is very strange and I am not sure what that would start happening.

You can try restoring the default Corel setting that came when your software was new.

To do this press F8 and while holding it down open CorelDraw and defaults will be restored.

Curious if that works for you in this situation.
Post Reply

Return to “Corel Draw Graphics Suite”