Hypertherm Sensor PHC

Cut quality issues can be discussed here, most common issues have been discussed here and should help you.
Post Reply
Rodman
1 Star Member
1 Star Member
Posts: 10
Joined: Wed Jun 24, 2009 3:13 pm

Hypertherm Sensor PHC

Post by Rodman »

I recently installed a Hypertherm Sensor PHC (Torch Height Control) on my Koike Monograph machine and had all kinds of fits wiring it up to my Burny 1250, after several calls to Hypertherm, somebody informed me that their wiring diagram was wrong, after getting it straightened out it works beautifully, and helps to make some of the nicest cuts I have ever seen, keep this in mind if anyone has or will in the future purchase one of these.
Top
User avatar
admin
Site Admin
Posts: 368
Joined: Thu Jul 03, 2008 5:12 pm
Location: Out In The Shop
Contact:
Contact admin

Re: Hypertherm Sensor PHC

Post by admin »

Thanks for the heads up Rodman.

Admin
Top
Post Reply

Return to “Plasma Cut Quality Forum”