cutting not equal

Cut quality issues can be discussed here, most common issues have been discussed here and should help you.
Post Reply
paddy ireland
1/2 Star Member
1/2 Star Member
Posts: 2
Joined: Sun May 24, 2020 4:41 pm

cutting not equal

Post by paddy ireland »

Hi i would appreciate any light you could shed on my problem <i built my own plasma cutting table which works very well,however when i do a drawing of a rectangle say 300x200 and put a 20 mm hole in the centre and cut on the plasma table the hole is off centre on the x axis by 5mm ok on the y axis so all feed back appreciated. Tnx in advance
adbuch
6 Star Elite Contributing Member
6 Star Elite Contributing Member
Posts: 8599
Joined: Thu Sep 21, 2017 5:22 pm
Location: Tucson, Arizona
Contact:

Re: cutting not equal

Post by adbuch »

Hi Paddy,
Please post your dxf file so we can see if it is a problem with your file or other issue.
Thanks,
David
Post Reply

Return to “Plasma Cut Quality Forum”