plasma arc do not stops right away

Cut quality issues can be discussed here, most common issues have been discussed here and should help you.
Post Reply
belloutiplasma
1/2 Star Member
1/2 Star Member
Posts: 4
Joined: Sat Apr 20, 2019 3:12 am

plasma arc do not stops right away

Post by belloutiplasma »

hello sir
i have a problem with my cnc plasma table
the plasma arc do not stops right away when finishing cutting of a piece
the torch moves to next pierce but torch do not stops right away
i attached a picture of a cutted piece it is supposed to start and end with quarter circle but it continues to cut a little bit more
i will be grateful if you can help me solve this problem
thank you
IMG_0071.JPG
weldguy
4 Star Elite Contributing Member
4 Star Elite Contributing Member
Posts: 1929
Joined: Fri Apr 17, 2009 11:48 am

Re: plasma arc do not stops right away

Post by weldguy »

Sticky relay in your controller? What equipment are you running?
User avatar
acourtjester
6 Star Elite Contributing Member
6 Star Elite Contributing Member
Posts: 7770
Joined: Sat Jun 02, 2012 6:04 pm
Location: Pensacola, Fla

Re: plasma arc do not stops right away

Post by acourtjester »

If you are using SheetCam you may have the overcut set with a value. ;)
cut.JPG
cut.JPG (59.84 KiB) Viewed 540 times
DIY 4X4 Plasma/Router Table
Hypertherm PM65 Machine Torch
Drag Knife and Scribe
Miller Mig welder
13" metal lathe
Small Mill
Everlast PowerTig 255 EXT
Post Reply

Return to “Plasma Cut Quality Forum”