It is currently Fri Oct 19, 2018 8:15 pm

 

Table not cutting square

Plasma Cut Quality can often be an issue for many of us. Check here if you have plasma cut quality issues. Ask a question, look for advice, post a helpful tip here.
Dooggins1
Posts: 13
Joined: Sun Jul 23, 2017 9:16 pm

Table not cutting square

Postby Dooggins1 » Sun Dec 31, 2017 3:34 pm

I am having an issue with my table not cutting a square, square. I have turned it off and moved it to the front until it's stops to try and square it back up but hasn't helped at all. Any suggestions??

User avatar
acourtjester
Elite Contributing Member
Elite Contributing Member
Posts: 3151
Joined: Sat Jun 02, 2012 6:04 pm
Location: Pensacola, Fla

Re: Table not cutting square

Postby acourtjester » Sun Dec 31, 2017 4:17 pm

It would help if you state what table you have, there are many users here that have different manufactures tables. Maybe someone who has that brand can be a better help for you. Is this a new table, DIY, dual motors ect.
DIY 4X4 Plasma/Router Table
CandCNC DTHC-IV & Feather Touch
Hypertherm PM65 Machine Torch
Drag Knife and Scribe
Miller Mig welder
13" metal lathe
Small Mill
Everlast PM 256 tig

Dooggins1
Posts: 13
Joined: Sun Jul 23, 2017 9:16 pm

Re: Table not cutting square

Postby Dooggins1 » Mon Jan 01, 2018 1:57 pm

acourtjester wrote:It would help if you state what table you have, there are many users here that have different manufactures tables. Maybe someone who has that brand can be a better help for you. Is this a new table, DIY, dual motors ect.



The brand is gorilla machines. He is based out of Asheville nc. I believe only one motor on the side.

User avatar
acourtjester
Elite Contributing Member
Elite Contributing Member
Posts: 3151
Joined: Sat Jun 02, 2012 6:04 pm
Location: Pensacola, Fla

Re: Table not cutting square

Postby acourtjester » Mon Jan 01, 2018 2:44 pm

Well they have "24-hour support following sell". Toll-Free: 800-340-5526 Local Tel: 828-593-0405
Feel Free to give us a call anytime. We love to talk shop and are happy to answer any questions you might have.
If that is a bolt together table it may have gotten out of square and may need to be adjusted to make it square again. :(
DIY 4X4 Plasma/Router Table
CandCNC DTHC-IV & Feather Touch
Hypertherm PM65 Machine Torch
Drag Knife and Scribe
Miller Mig welder
13" metal lathe
Small Mill
Everlast PM 256 tig

Old Iron
Elite Contributing Member
Elite Contributing Member
Posts: 439
Joined: Wed Nov 26, 2014 5:12 pm

Re: Table not cutting square

Postby Old Iron » Mon Jan 01, 2018 5:35 pm

Measure diagonally across the the table both directions and if the measurements aren't the same then, make them the same.


Return to “Plasma Cut Quality Forum”

Who is online

Users browsing this forum: No registered users and 8 guests

Easyscriber engrave attachment for Hypertherm torch's