Funky sparks

Cut quality issues can be discussed here, most common issues have been discussed here and should help you.
Post Reply
iron2
2 Star Member
2 Star Member
Posts: 62
Joined: Fri Oct 31, 2014 2:04 pm

Funky sparks

Post by iron2 »

I have looked into this a bit and replaced the o ring in the nozzle. The end cap venting holes were half shut and i reamed so all are open now but still getting issue. Bought a new cap but was wrong size. T45 cnc. Need new shield?
Homebuilt 2x4 water table
Torchmatecad
Flashcut THC
Hypotherm 45
iron2
2 Star Member
2 Star Member
Posts: 62
Joined: Fri Oct 31, 2014 2:04 pm

Re: Funky sparks

Post by iron2 »

iron2 wrote:I have looked into this a bit and replaced the o ring in the nozzle. The end cap venting holes were half shut and i reamed so all are open now but still getting issue. Bought a new cap but was wrong size. T45 cnc. Need new shield?
sorry had video didn't send.
Homebuilt 2x4 water table
Torchmatecad
Flashcut THC
Hypotherm 45
Post Reply

Return to “Plasma Cut Quality Forum”