Powermax 105 1/2 plate with 105 amp consumables

Cut quality issues can be discussed here, most common issues have been discussed here and should help you.
Post Reply
Dynatorch78
Posts: 20
Joined: Thu Jan 07, 2016 5:23 pm

Powermax 105 1/2 plate with 105 amp consumables

Post by Dynatorch78 » Fri Mar 15, 2019 9:15 pm

owermax 105 1/2 plate with 105 amp consumables
Post Fri Mar 15, 2019 8:38 pm

So I've been told over an over to use the smallest consumables at the lowest amperage possible for the best cuts over and over.
I have a job that is 1/2 steel plate that needs to be deadly accurate. I usually use 65 amp stuff for that and it works fine. I tried 45 amp and that was no fun whatsoever. I figured what the hell, let's crank it up. 105 amps 141 volts, .7 second pierce delay, 60 inches per minute, corner speed is 85 percent of that. Machine is a Dynatorch xls 5x10.

Best cuts I've ever seen on 1/2 plate that was not high definition. Crank it up and let her eat!! Parts are dead nuts

Jaime Branco
Posts: 19
Joined: Sun Apr 03, 2016 5:06 am

Re: Powermax 105 1/2 plate with 105 amp consumables

Post by Jaime Branco » Sat Mar 16, 2019 5:30 am

Pictures

Post Reply

Return to “Plasma Cut Quality Forum”

Easyscriber engrave attachment for Hypertherm torch's