Is this going to cut correctly?

michelle · Post by **michelle** » Mon Apr 30, 2018 5:26 pm

Can someone take a look at this file and tell me if it looks like it will cut correctly? It wasn't right when it was done originally but I 'think' I have it fixed, I just need an expert to check it before I waste more material!

Thanks guys!
Michelle

Post by **weldguy** » Tue May 01, 2018 2:35 pm

Try posting this in the file sharing forum and you will reach more members and likely get the help your looking for. I cannot open pcm files or I would take a look.

michelle · Post by **michelle** » Fri May 04, 2018 10:25 pm

I cut it and it worked. Thank you!

Post by **rdj357** » Fri May 04, 2018 11:38 pm

Here you go, I cleaned it up and fixed the unlinked paths out in the middle that were piercing on the path. Bridged in some details in the wings that were fallouts, reshaped the left eye and added a touch of detail, thickened the antennae just a little for strength, and scaled back some open path details that were close to cutting to the edge. I do custom file work if I can ever help - robert@490Creations.com

Hope this helps a little!

Is this going to cut correctly?

Is this going to cut correctly?

Re: Is this going to cut correctly?

Re: Is this going to cut correctly?

Re: Is this going to cut correctly?