File needed for watertable tank.
- wishiwastorching
- 2.5 Star Member
- Posts: 108
- Joined: Sat Jun 11, 2011 10:14 pm
File needed for watertable tank.
I'm working on the tank of my watertable and I need to cut out the slat holder thats going to runt he length of the tank on both sides. I thought if someone else has built one lately and had it on file I could just cut it out. I'm looking for approx. 2.5 inch slats at about 1.5 inches appart. It's for my 2x4 table with 4 inch tank.
-
- 3 Star Member
- Posts: 427
- Joined: Wed Sep 29, 2010 12:19 am
Re: File needed for watertable tank.
Here is link to some slat holders I posted a while back. They are for 3/16" slats and three inch centers, I think they are 2-1/2" deep though.
http://plasmaspider.com/viewtopic.php?f=6&t=3365
I made them out of 5/16' plate.
WSS
http://plasmaspider.com/viewtopic.php?f=6&t=3365
I made them out of 5/16' plate.
WSS
-
- 3 Star Member
- Posts: 487
- Joined: Sun Mar 27, 2011 10:13 pm
Re: File needed for watertable tank.
I will need some of the slat holders. Thanks Tom
Jim
Jim
-
- 3 Star Member
- Posts: 395
- Joined: Sun Jan 02, 2011 11:03 pm
Re: File needed for watertable tank.
Here are my slat supports. I used 1/8" x 2.75" flat bar for my slats, so this is drawn for 3/16" slots. (on 1.5" centers) There are two, the ends of my table and the middle one--the only difference is the middle one has little holes along the bottom to let water through.
My table is 56" wide inside, and 4" deep. You won't need them quite as long as drawn....
My table is 56" wide inside, and 4" deep. You won't need them quite as long as drawn....
You currently do not have access to download this file.
To gain download access for DXF, SVG & other files Click Here
- wishiwastorching
- 2.5 Star Member
- Posts: 108
- Joined: Sat Jun 11, 2011 10:14 pm
Re: File needed for watertable tank.
I Lean, Thanks! I am going to use this on my table. appreciate your help!