THC Stop after Tip on the plate

[brunnbauer]

Hello,

i need your help.

i have
Controller: CC-s3c
THC: sf_hc25g

i have the problem: The Torch tip on the plate, drive up and move directly for cutting.
How can I set a pause after lifting --- before movement xy takes place

Note: I only care about the break after lifting.

For information: THC works-
i can set the voltage: drive up and down.
Arc delay: piercing time doesn't really work because the torch moves immediately.
IHS Delay: work - tip on the plate and drive up the the value I set

i hope you can help me. you find my setting and the manual in the annex.

Thank you

[weldguy]

I am not all familiar with the equipment you are workjng with however i would experiment with the last 3 settings in the first column, Pierce Time, First Pierce Time, and Move Pierce Time. Currently the values are 0.1 which if in seconds is a very short period of time. Try something drastic like 5.0 and see if delays for 5 seconds before moving. I am also guessing that First Pierce time should be set longer than the others since many plasma cutters require more time on the first since air is not yet flowing through the torch. I could be way off but cant hurt to try.