Hi,
Just received a new CNC.
Running;
Hypertherm 65,
Controller is: Start Shaphon CC-M3
Torch Height is: Microstep SH-HC31
Wish to use ProNest software with an air scribe,
Is there a way to program scribe offsets in the controller?
Thanks in advance,
Justin
Start Shaphon with air scribe
-
- 4 Star Elite Contributing Member
- Posts: 1364
- Joined: Tue Feb 28, 2012 6:47 pm
Re: Start Shaphon with air scribe
air scribe is typically supported by the CAM side (software) . Don't know if Pronest supports anything but plasma. Torch height is not used for air scribe or engraving (plate marking) Controller just needs one switched aux output the rest is software.