MOCK UP OF DESIGN
-
- 1 Star Member
- Posts: 11
- Joined: Sun Jan 27, 2019 12:01 am
MOCK UP OF DESIGN
Hello what does everyone use to make a mock up for a customer of what this finish product will look like . i am trying to do a portrait and want to see what the cut will look like before i cut it. Thanks in advance.
- acourtjester
- 6 Star Elite Contributing Member
- Posts: 7801
- Joined: Sat Jun 02, 2012 6:04 pm
- Location: Pensacola, Fla
Re: MOCK UP OF DESIGN
For a single layer cut I would just do a screenshot of the SheetCam display image, If you are talking and a multi-part assembly, that is much harder and would require them paying for you time up front. I would be a little careful with a customer that does not know what they are asking for, or what it should already look like. You could do all the work for a setup and they then walk on you, your time down the tubes.
DIY 4X4 Plasma/Router Table
Hypertherm PM65 Machine Torch
Drag Knife and Scribe
Miller Mig welder
13" metal lathe
Small Mill
Everlast PowerTig 255 EXT
Hypertherm PM65 Machine Torch
Drag Knife and Scribe
Miller Mig welder
13" metal lathe
Small Mill
Everlast PowerTig 255 EXT
-
- 1 Star Member
- Posts: 11
- Joined: Sun Jan 27, 2019 12:01 am
Re: MOCK UP OF DESIGN
This is for more of custom portrait work. So I can show them the end result pretty much everything else is what it is when you create it.