New to forum. I'm sure this has been asked.....I just can't find a thread on it. I have a plasmaCAM dhc model. I had it for 14 years now. It quit cutting. Narrowed down to the dhc controller on table. Opened it up found some resistors that got hot and other things that got hot. Got a guy that is a electrical repair guy......board is burnt beyond repair. I'm in need of a dhc controller. I'm not paying the 3K from plasmaCAM for a $700 CONTROLLER. I only use machine for a few hours a day so a used one that works or New one for the $700 would work for me. I have work building up and I need a resolution on this. I can not afford the 3k for the "update".
Thanks in advanced.
DHC table controller
-
Tautog13
- 1.5 Star Member
- Posts: 46
- Joined: Fri Feb 17, 2017 4:12 pm
Re: DHC table controller
You may find something in this thread: viewtopic.php?f=61&t=27926
