Secure smaller metal to table

Specialkfab · Post by **Specialkfab** » Tue Nov 27, 2018 9:37 pm

I have some approx 12" scrap discs that I want to cut and not throw away. Problem is I start the cut when the torch contacts the metal to set the cut height the disc bounces. This usually results in moving the metal. Any ideas to secure it to the grid. The grid is a Plasmacam. No horizontals to clamp to. Any ideas entertained. Thanks

SegoMan DeSigns · Post by **SegoMan DeSigns** » Tue Nov 27, 2018 9:50 pm

Take a square pce of metal and cut a hole in it big enough for the circles to go into, tack a couple of tabs under it..

Post by **djreiswig** » Tue Nov 27, 2018 11:26 pm

Ohmic.

Post by **chasxjs** » Wed Nov 28, 2018 12:25 am

viewtopic.php?f=87&t=23665&p=153431&hil ... ps#p153431
Have you seen this thread?

Specialkfab · Post by **Specialkfab** » Wed Nov 28, 2018 2:07 am

chasxjs wrote: ↑Wed Nov 28, 2018 12:25 am viewtopic.php?f=87&t=23665&p=153431&hil ... ps#p153431
Have you seen this thread?

Thank you so much. Makes so much sense. Was going crazy trying to figure it out. I knew it could be done some how.

Secure smaller metal to table

Secure smaller metal to table

Re: Secure smaller metal to table

Re: Secure smaller metal to table

Re: Secure smaller metal to table

Re: Secure smaller metal to table