It is currently Mon Oct 15, 2018 9:54 pm

 

New and almost figured out... need help.

CNC Plasma Cutters are amazing and there is always plenty of knowledge to share and discuss. Use the CNC plasma cutters general forum for this purpose.
KrakenNewbie
Posts: 1
Joined: Fri May 18, 2018 5:54 pm

New and almost figured out... need help.

Postby KrakenNewbie » Fri May 18, 2018 5:59 pm

So i am having a good time with the torchmate X. Ive got my gcode all setup and imported into the Vmd to start cutting. Dry test perfect.

When i go to cut, the todcch doesnt lower or ignite and simply traces it in the air like during the dry run.

Im positive its a basic mistake im making.

Any advice?

Return to “CNC Plasma Cutters General Forum”

Who is online

Users browsing this forum: No registered users and 12 guests

Easyscriber engrave attachment for Hypertherm torch's