Easyscriber engrave attachment for Hypertherm torch's
 

Plasma Cutter Issue: Please Help

CNC Plasma Cutters are amazing and there is always plenty of knowledge to share and discuss. Use the CNC plasma cutters general forum for this purpose.
Post Reply
PremierAutoExhaust
Posts: 1
Joined: Mon Jan 01, 2018 1:00 pm

Plasma Cutter Issue: Please Help

Post by PremierAutoExhaust » Mon Jan 01, 2018 1:10 pm

Hello,

I'm having issues with my Hobart AirForce 40I Plasma Cutter. It works fine 70% of the time however, sometimes does not cut. The flame or arc does not cut through the aluminum and simply releases air. I purchased the plasma about two weeks ago.

I am cutting 16 Gauge Aluminum Tubing. Does anybody know what the best setting would be to cut the aluminum with? The settings start from 20-35A.

The cutting tip is new and not clogged.

Kind Regards,

Jameel Yar

jimcolt
Elite Contributing Member
Elite Contributing Member
Posts: 2952
Joined: Mon Jul 20, 2009 11:18 pm
Location: New Hampshire

Re: Plasma Cutter Issue: Please Help

Post by jimcolt » Wed Jan 03, 2018 10:04 am

I would suggest contacting technical support at Hobart. Jim Colt Hypertherm

Post Reply