Easyscriber engrave attachment for Hypertherm torch's
 

Have had a win! I think

CNC Plasma Cutters are amazing and there is always plenty of knowledge to share and discuss. Use the CNC plasma cutters general forum for this purpose.
Post Reply
BensPlasmaAu
Posts: 196
Joined: Mon Jan 13, 2014 10:37 am
Location: Boronia, Melbourne, Australia

Have had a win! I think

Post by BensPlasmaAu » Fri Nov 03, 2017 6:46 am

https://youtu.be/4vD9F7hRZEo

Finally got a chance to spend more than an hour at the workshop today and dove headlong into the biggest cut l have ever attempted.

Not too bad really.

User avatar
acourtjester
Elite Contributing Member
Elite Contributing Member
Posts: 3281
Joined: Sat Jun 02, 2012 6:04 pm
Location: Pensacola, Fla

Re: Have had a win! I think

Post by acourtjester » Fri Nov 03, 2017 7:33 am

Congrates :D it is great when a project funnels down to the finish and you see the first fruits of your labor come out. I bet you knocked back a few cool ones. :lol:
DIY 4X4 Plasma/Router Table
CandCNC DTHC-IV & Feather Touch
Hypertherm PM65 Machine Torch
Drag Knife and Scribe
Miller Mig welder
13" metal lathe
Small Mill
Everlast PM 256 tig

BensPlasmaAu
Posts: 196
Joined: Mon Jan 13, 2014 10:37 am
Location: Boronia, Melbourne, Australia

Re: Have had a win! I think

Post by BensPlasmaAu » Fri Nov 03, 2017 7:00 pm

acourtjester wrote:Congrates :D it is great when a project funnels down to the finish and you see the first fruits of your labor come out. I bet you knocked back a few cool ones. :lol:
You better believe it!!

User avatar
SeanP
Elite Contributing Member
Elite Contributing Member
Posts: 794
Joined: Thu Aug 01, 2013 11:50 am
Location: Co Kerry, Ireland

Re: Have had a win! I think

Post by SeanP » Sat Nov 04, 2017 4:41 am

Good stuff, you gave it a good test there!
It's a never ending learning experience with this stuff, hopefully it should get easier from now on for you.
Powermax 45 with Duramax torch.
Home built table, Candcnc DTHC 2, Dragoncut 620-4
R-Tech 210 Tig, Jasic 250 mig
Sheetcam, Scanything, Coreldraw X8, Solidworks
Table build gallery

Post Reply