Ways to cut AR500 steel targets with a Cut 50 plasma cutter

New to PlasmaSpider? Introduce yourself to the community and tell us a little about you.
Post Reply
Jeffjeffers
1/2 Star Member
1/2 Star Member
Posts: 4
Joined: Thu Feb 23, 2023 6:17 pm

Ways to cut AR500 steel targets with a Cut 50 plasma cutter

Post by Jeffjeffers »

I am looking into ways to cut AR500 steel targets with a Cut 50 plasma cutter So far I’ve managed to make really pitiful ragged cuts in 1/4” AR500 steel and I was assuming that a cut 50 running in 220v would do this well. I am wondering what I’m doing wrong. Any suggestions?
Top
adbuch
6 Star Elite Contributing Member
6 Star Elite Contributing Member
Posts: 8706
Joined: Thu Sep 21, 2017 5:22 pm
Location: Tucson, Arizona
Contact:
Contact adbuch

Re: Ways to cut AR500 steel targets with a Cut 50 plasma cutter

Post by adbuch »

Perhaps share some photos of your cuts, and tell us more about your settings. Which table/controller are you using?
David
Top
Post Reply

Return to “Introduce Yourself”