good morning everyone i am new in this forum and i want to participate in this great work.
so i will start with a question in anti collision systeme, how to connect the proximity sensor (anti collision) in Mach3 board ?
if with the z axis limit switches it will have the same display on mach3 software for anti collision and limit switches
anti collision systeme
-
acourtjester
- 6 Star Elite Contributing Member
- Posts: 7801
- Joined: Sat Jun 02, 2012 6:04 pm
- Location: Pensacola, Fla
Re: anti collision systeme
What has been discussed here is not an anti collision system but a system where the torch can fall away if it collides with something.
This type has a additional switch connected with the other switches so Mach gets told of the torch drop away. This is not displayed separately in Mach. Most are a magnetic holding assembly for the torch that holds it in the correct position until the torch collides and falls away.
This type has a additional switch connected with the other switches so Mach gets told of the torch drop away. This is not displayed separately in Mach. Most are a magnetic holding assembly for the torch that holds it in the correct position until the torch collides and falls away.
DIY 4X4 Plasma/Router Table
Hypertherm PM65 Machine Torch
Drag Knife and Scribe
Miller Mig welder
13" metal lathe
Small Mill
Everlast PowerTig 255 EXT
Hypertherm PM65 Machine Torch
Drag Knife and Scribe
Miller Mig welder
13" metal lathe
Small Mill
Everlast PowerTig 255 EXT
