NEW GUY

New to PlasmaSpider? This is where you introduce yourself to the community.
Post Reply
cncplasmaworkz
Posts: 4
Joined: Mon Apr 15, 2019 6:30 pm

NEW GUY

Post by cncplasmaworkz » Thu May 16, 2019 11:03 am

CNC PLASMAWORKZ & METAL FAB
Located out of Sweetwater TX
4x8 flat deck Premier Plasma table & waterbed
Miller Spectrum 375 (XT30 handheld torch)
Inkscape sheetcam & Mach 3
Proma compact THC (Please message if you can help walk me through install on a miller!!!!)

plasmanewbie
Elite Contributing Member
Elite Contributing Member
Posts: 563
Joined: Thu Jul 24, 2008 11:15 am

Re: NEW GUY

Post by plasmanewbie » Fri May 17, 2019 9:31 am

Welcome to the site. Shouldn't bo too tough to get your Miller wired up. Post any specific questions and I am sure you will find help :Like

Post Reply

Return to “Introduce Yourself”

Easyscriber engrave attachment for Hypertherm torch's