0-30 Solutions Poll - Vote for the solution that worked for you

Find solutions to error 0-30 and share your experiences. Be sure to vote for the solution that worked for you.
Post Reply

0-30 - Torch consumables stuck

Remove, inspect and re-install consumables
1
33%
Flow restriction caused by plugged filter
0
No votes
Flow restriction caused by too small of air line being used
0
No votes
Worn or damaged swirl ring
1
33%
Worn or damaged electrode
1
33%
 
Total votes: 3

User avatar
admin
Site Admin
Posts: 364
Joined: Thu Jul 03, 2008 5:12 pm
Location: Out In The Shop
Contact:

0-30 Solutions Poll - Vote for the solution that worked for you

Post by admin » Mon Jan 13, 2020 4:30 pm

Error code 0-30 is an error where the PowerLED remains ON and the Fault LED remains turns ON. Your system will not operate during this code and the issue must be solved before you can continue.

The electrode is spring loaded and must move freely inside the swirl ring in order to get the pilot arc started. Your consumables need to be in good condition in order for this to take place and worn or damaged comsumables is often the reason for this error.

Post a reply to this topic if you have additional information about your solution or a solution that you do not see listed above.

Post Reply

Return to “0-30 - Torch consumables stuck”

Easyscriber engrave attachment for Hypertherm plasma cutters.