entry way

ford_gt2005 · Post by **ford_gt2005** » Sat Jun 22, 2019 1:21 pm

Here is a entry sign we did for a couple going into there ranch. It is 19.5 ft wide 3.5 ft high cut out of 1/4in mild steel just left to rust naturally

Post by **djreiswig** » Sat Jun 22, 2019 2:16 pm

Beautiful.

Post by **Larry83301** » Wed Jul 03, 2019 10:02 am

Very nice, you must have a large machine!

Larry

Post by **BAR M** » Thu Jul 04, 2019 9:48 am

Good job. Nice, clean design.

Post by **Zippo** » Sun Jul 21, 2019 4:32 am

Nice job...

JohnnyC · Post by **JohnnyC** » Wed Jul 24, 2019 12:29 pm

SegoMan DeSigns · Post by **SegoMan DeSigns** » Wed Jul 24, 2019 2:28 pm

Looks good, how many section are there to it or do you have a 20' plaz table?

Post by **Rex** » Sun Jul 28, 2019 1:17 pm

Very Nice

ford_gt2005 · Post by **ford_gt2005** » Wed Jul 31, 2019 8:32 pm

we did it in 3 sections

Larry83301 wrote: ↑Wed Jul 03, 2019 10:02 am Very nice, you must have a large machine!

Larry

ford_gt2005 · Post by **ford_gt2005** » Wed Jul 31, 2019 8:33 pm

we did it in 3 sections. we have a 4x8 table

SegoMan DeSigns wrote: ↑Wed Jul 24, 2019 2:28 pm Looks good, how many section are there to it or do you have a 20' plaz table?

entry way

entry way

Re: entry way

Re: entry way

Re: entry way

Re: entry way

Re: entry way

Re: entry way

Re: entry way

Re: entry way

Re: entry way