Page 1 of 1

Graveyard Carz tribute

Posted: Wed Jan 09, 2019 5:39 pm
by gtojim
Here is my latest creation, I will be shipping it to Mark Worman
49864946_283929668862441_6688706892530712576_n.jpg
49803797_283929895529085_3821050696069808128_n.jpg
49735023_283929712195770_3460534809145638912_n.jpg
49707234_283929638862444_8907477054795022336_n.jpg
49669451_283929675529107_7193312253561536512_n.jpg
49586411_283929868862421_5729369919120736256_n.jpg
49503072_283929615529113_5180231146004283392_n.jpg
49450545_283929755529099_3084386551229054976_n.jpg
49343091_283929798862428_4627282311694516224_n.jpg
49305805_283929632195778_5003460750346289152_n.jpg

Re: Graveyard Carz tribute

Posted: Wed Jan 09, 2019 7:22 pm
by acourtjester
No problems there I'm sure he will love it, very creative work :D
How big was to original saw blade. Thanks for posting.

Re: Graveyard Carz tribute

Posted: Wed Jan 09, 2019 8:57 pm
by dgeorgester
One of my favorite shows. :)

Re: Graveyard Carz tribute

Posted: Thu Jan 10, 2019 5:08 am
by East German
Yes
Very Nice

Re: Graveyard Carz tribute

Posted: Thu Jan 10, 2019 10:37 am
by gtojim
It was 30" diameter

Re: Graveyard Carz tribute

Posted: Thu Jan 10, 2019 11:14 am
by Larry83301
Great design work, love the coloring and the arch!


Larry

Re: Graveyard Carz tribute

Posted: Fri Jan 11, 2019 10:38 am
by all4sho
that is wild!! great work

Re: Graveyard Carz tribute

Posted: Sat Jan 12, 2019 12:21 pm
by Old Iron
Looks cool!!!!!!!!!!!!!!!!!!!

Re: Graveyard Carz tribute

Posted: Thu Jan 24, 2019 9:57 am
by ggeh
Impressive very creative design. Can I ask how you went about centering your torch to the saw blade?

Re: Graveyard Carz tribute

Posted: Thu Jan 24, 2019 12:34 pm
by SegoMan DeSigns
Awesome design!
ggeh wrote:
Thu Jan 24, 2019 9:57 am
Can I ask how you went about centering your torch to the saw blade?
What I do when I need to do a cut in an existing piece is to incorporate the outer edge into the file, do a couple of dry runs for alignment. Turn on the torch to cut the inside pieces pause and remove part.

Re: Graveyard Carz tribute

Posted: Thu Jan 24, 2019 3:32 pm
by gtojim
ImageI first set a zero position, then On my screen in visual designer I put the cross hairs in the middle of the drawing and then I lowered the torch head and lined up the saw blade to the exact middle, the hole was 6 inches across so I placed a grinder wheel in the hole to get the exact center, then I prayed to the plasma lords and hit "run"

Re: Graveyard Carz tribute

Posted: Fri Jan 25, 2019 3:24 am
by ggeh
Thank you both for the setup info, very helpful.