Anyone have dxf files for these they would share?
http://somentecoisaslegais.com.br/arte/ ... om-o-vento
Dave Hanks
Amazing wind Art
-
- 4.5 Star Elite Contributing Member
- Posts: 1649
- Joined: Tue Feb 22, 2011 5:15 pm
- Location: Mountain City, Tennessee
- acourtjester
- 6 Star Elite Contributing Member
- Posts: 7784
- Joined: Sat Jun 02, 2012 6:04 pm
- Location: Pensacola, Fla
Re: Amazing wind Art
After looking at the top one you can see each of the moving parts are a series of cupped discs pairs. There are 2 large discs mounted near the center pivot point shown in red
then the next size smaller following this pattern out to the tip. Each "S" section is mounted on a tubular circle which passes through the center pivot point of each section. Each is linked to the next section so as they rotate about the tubular circle together in a inside out pattern.
then the next size smaller following this pattern out to the tip. Each "S" section is mounted on a tubular circle which passes through the center pivot point of each section. Each is linked to the next section so as they rotate about the tubular circle together in a inside out pattern.
- Attachments
-
- windmill.JPG (18.81 KiB) Viewed 1363 times
DIY 4X4 Plasma/Router Table
Hypertherm PM65 Machine Torch
Drag Knife and Scribe
Miller Mig welder
13" metal lathe
Small Mill
Everlast PowerTig 255 EXT
Hypertherm PM65 Machine Torch
Drag Knife and Scribe
Miller Mig welder
13" metal lathe
Small Mill
Everlast PowerTig 255 EXT
-
- 1/2 Star Member
- Posts: 2
- Joined: Wed Dec 05, 2018 11:58 am
Re: Amazing wind Art
Anthony Howe is a member here, p.m. him .
His wind art is amazing, check out his website.
If I could afford one I would just sit in my yard and watch it all day.
His wind art is amazing, check out his website.
If I could afford one I would just sit in my yard and watch it all day.
-
- 4.5 Star Elite Contributing Member
- Posts: 1814
- Joined: Mon Jun 12, 2017 6:43 pm