Here's a little design I came up with for a heat pump cover. I think powder coating is the real ticket here.
For the wood, I just used fence boards from the local hardware store. Perforated plate was used for the front.
The top curved part, I used 20ga steel and the little hand bender. 16ga is tuff to work with. If you don't have a slip roll, don't even try with anything less than 20ga. Frustration will get the best of you.
I used a piece of 4 x1/4 flat bar with 4 short pieced of angles to secure to the base (see picture)
heat pump covers
- dgeorgester
- 2.5 Star Member
- Posts: 127
- Joined: Wed Oct 24, 2012 7:20 pm
- Location: Halifax, Nova Scotia, Canada
-
- 2 Star Elite Contributing Member
- Posts: 67
- Joined: Fri Oct 06, 2017 2:18 am
- Location: N. Lincs, UK
- Contact:
Re: heat pump covers
Love it, I have 2 ugly looking heat pumps also