Jake

[DXF]

"Jake" my Velociraptor....finally cut one. T Rex, Triceratops and Pteradactil.

Dave Hanks

[Doc Hollywood]

Very nice! I figured out on these, that I can nest the parts tighter than the dxf comes. I did a spider, and was surprised at how much space it took up.

[Buzzard Gut]

Looks Cool Dave! I've got a couple I cut awhile back that I have to weld up for my grandson.

[duramaxer]

looks BAD ASS

[beefy]

Very nice! I figured out on these, that I can nest the parts tighter than the dxf comes.

That's what I did too. I can get over 4 of the velociraptor on one sheet so the cost of steel is quite small. They're quite easy to put together too. I took the velociraptor to work and got quite a few oohs and aahhs and nice estimates of what it's worth.

Of course nobody pulled their wallet out

[Doc Hollywood]

I did the same with a spider. I've had a good size spider assembled for about a year, and no takers. I'm going to try to sell it again this year during craft show season!

[DXF]

Thanks. They cut and assemble real nice! I wasn't planning on trying to sell these but a local weld shop owner wants one of each. Glued all of these together with Loctite Ultra gel super glue. Planning on making some larger ones out of 12 gage and tack welding them.

Dave Hanks

[Gamelord]

Those are totally awesome. When I get a chance I am going to build some for the yard.

[DXF]

Finally got Jake powder coated with silver vein and took him for a hike on the AT for pictures.

Dave Hanks