Gate
-
- 2 Star Member
- Posts: 67
- Joined: Wed Aug 12, 2009 2:03 pm
Gate
I just put up this gate last weekend, the radius on the top corners were to tight to bend out of 2" tube so I cut the radius on my plasmacam then bent 2" flatbar with hossfeld bender welded it all together. I was pleased with the outcome, more important so was the customer. the large gate is 16' single swing gate, the man gate is 4'
- AnotherDano
- 4 Star Member
- Posts: 806
- Joined: Fri Dec 18, 2009 11:52 pm
- Location: Laramie, Wyoming
- Contact:
Re: Gate
Nice, clean design and you gave it a nice touch with those tight-curve end corners.
Beautiful work!
Beautiful work!
Dano Roberts
droberts@ironpequod.com
PlasmaCam DHC-2 v3.11
Hypertherm PowerMax-30
Serving Laramie, Wy since Thursday
droberts@ironpequod.com
PlasmaCam DHC-2 v3.11
Hypertherm PowerMax-30
Serving Laramie, Wy since Thursday
- Loyd
- 3.5 Star Elite Contributing Member
- Posts: 686
- Joined: Tue Nov 03, 2009 12:28 am
- Location: Bald Knob, AR
- Contact:
Re: Gate
Those are nice, clean looking gates. Good job. Back in the day we used to charge by the square foot plus installation.
If you wouldn't mind, how do you bid your work? What would a job like that cost someone?
You certainly don't have to answer these questions but I'm curious.
Loyd
If you wouldn't mind, how do you bid your work? What would a job like that cost someone?
You certainly don't have to answer these questions but I'm curious.
Loyd
De inimico non loquaris sed cogites
Do not wish ill upon your enemies, plan it.
Do not wish ill upon your enemies, plan it.