command cnc error

CommandCNC related questions and tips can be posted to this topic.
Post Reply
[email protected]
Posts: 36
Joined: Mon May 07, 2018 5:27 pm
Location: Moose Jaw Sask.

command cnc error

Post by [email protected] » Fri Mar 15, 2019 2:13 pm

Here is an error file from my latest cut-file I've tried loading in cmnd cnc, it happens quite freqently where it doesn't want to open cmnd cnc, after a couple of tries it opens, can someone tell me why? TIA.
Attachments
ccc_err_2019-03-14_173802.zip
(74.83 KiB) Downloaded 11 times

BTA Plasma
Elite Contributing Member
Elite Contributing Member
Posts: 489
Joined: Thu May 12, 2011 4:28 pm

Re: command cnc error

Post by BTA Plasma » Fri Mar 15, 2019 3:57 pm

You mean your CommandCNC wont open or the cut file doesn't display?

Rodw
Posts: 200
Joined: Sun Aug 21, 2016 1:49 am

Re: command cnc error

Post by Rodw » Sat Mar 16, 2019 5:36 am

I wold escalate this to CandCNC support. Its likely that the Mesa 7i92 ethernet card is faulty or there is a loose wire on the power supply to it or something silly like that. I think its an intermittent hardware fault.

I've not seen that error before in your print_file and I use a similar Mesa ethernet card.

Code: Select all

hm2: loading Mesa HostMot2 driver version 0.15
hm2_eth: loading Mesa AnyIO HostMot2 ethernet driver version 0.2
hm2_eth: 10.10.10.10: Hardware address: 00:60:1b:12:01:96
hm2_eth: discovered 7I92
board fails HM2 registration
Shutting down and cleaning up LinuxCNC...
You can see that LinuxCNC finds the board at the expected IP address and the board is discovered but for some reason its not being loaded properly.

[email protected]
Posts: 36
Joined: Mon May 07, 2018 5:27 pm
Location: Moose Jaw Sask.

Re: command cnc error

Post by [email protected] » Sat Mar 16, 2019 10:45 am

I tried sending the file to cmmnd cnc support but couldn't get anywhere, I'll try again, thanks.

Rodw
Posts: 200
Joined: Sun Aug 21, 2016 1:49 am

Re: command cnc error

Post by Rodw » Sat Mar 16, 2019 3:34 pm

Post on the linuxcnc forum and make sure you reference the post title with "Mesa 7i92 not loading" or something and you'll get support from a user called PCW who is the main man at Mesa where your hardware comes form.

Post Reply

Return to “CommandCNC - Linux”

Easyscriber engrave attachment for Hypertherm torch's