DTHC-IV to DTHC-V upgrade

CandCNC plasma table components discussion forum
Post Reply
BRadix
1/2 Star Member
1/2 Star Member
Posts: 5
Joined: Sun Jan 16, 2022 7:09 pm

DTHC-IV to DTHC-V upgrade

Post by BRadix »

I just received a New DTHC-V card and I'm not sure if I got the right card. I do not want to install it until I'm sure. I am switching from a DTHC-IV. I requested the DTHC-V with Ribbon cable option. How does the DTHC-V connect to the UBOB? What I was able to find is it should connect through the 16pin ribbon cable (or direct with EBOB). What is the difference between the 2 DTHC-V card options? The card that I received will not connect to the ribbon cable.
weldguy
4 Star Elite Contributing Member
4 Star Elite Contributing Member
Posts: 1928
Joined: Fri Apr 17, 2009 11:48 am

Re: DTHC-IV to DTHC-V upgrade

Post by weldguy »

You may be best to contact C&CNC direct on this question. Certainly curious to know what you find out if you could post back.
robertspark
4.5 Star Elite Contributing Member
4.5 Star Elite Contributing Member
Posts: 1805
Joined: Mon Jun 12, 2017 6:43 pm

Re: DTHC-IV to DTHC-V upgrade

Post by robertspark »

tom comes on here from time to time, but the candc forum is probably where you'll get the best and fastest answers.


https://www.candcnc.net/supportforum/index.php

actually scratch that, as I see you have an answer.

https://www.candcnc.net/supportforum/vi ... =24&t=3172

(you'll need to register there for a look).
User avatar
djreiswig
4.5 Star Elite Contributing Member
4.5 Star Elite Contributing Member
Posts: 1929
Joined: Thu Nov 19, 2015 10:02 pm
Location: SE Nebraska

Re: DTHC-IV to DTHC-V upgrade

Post by djreiswig »

2014 Bulltear (StarLab) 4x8
C&CNC EtherCut
Mach3, SheetCam, Draftsight
Hypertherm PM65
Oxy/Acetylene Flame Torch
Pneumatic Plate Marker, Ohmic, 10 inch Rotary Chuck (in progress)
Post Reply

Return to “CandCNC Forum”