It is currently Sat Oct 20, 2018 7:45 pm

 

M10/M11

CandCNC plasma table components discussion forum
tcaudle
Posts: 1038
Joined: Tue Feb 28, 2012 6:47 pm

Re: M10/M11

Postby tcaudle » Sun May 13, 2018 5:36 pm

All the M codes except M10/M11 are macros in MACH . On some protiles the M code does more than just fire the torch, it also delays the motion until the ARC OK INDICATOR on the screen) is on . it used on systems with longer torch hoses . If it works for you then use it. It makes no real sense why it won't work without it unless your M43 macro in MACH is different.

djreiswig
Elite Contributing Member
Elite Contributing Member
Posts: 344
Joined: Thu Nov 19, 2015 10:02 pm

Re: M10/M11

Postby djreiswig » Sun May 13, 2018 6:41 pm

Thanks for the reply. My M03 macro just has the DoSpinCW() command. I'll have to look at M43. Not familiar with that one. Never seen it in my gcode.
If I include the M03 it's like it overrides the M11 and makes the torch stay on.
If I don't use the M03 then I shouldn't need M05 either, correct? Since the M10 will shut the torch off.
I just remember reading a post from you that said you needed to have both M03 and M11, but I wasn't sure what would happen if you didn't.
2014 Bulltear (StarLab) 4x8
C&CNC EtherCut
Mach3, SheetCam, Draftsight
Hypertherm PM65
Oxy/Acetylene Flame Torch
Pneumatic Plate Marker, Ohmic, 10 inch Rotary Chuck (in progress)


Return to “CandCNC”

Who is online

Users browsing this forum: No registered users and 2 guests

Easyscriber engrave attachment for Hypertherm torch's