It is currently Sat Nov 17, 2018 10:42 am


Feathertouch & torch volts

CandCNC plasma table components discussion forum
Elite Contributing Member
Elite Contributing Member
Posts: 361
Joined: Thu Nov 19, 2015 10:02 pm

Feathertouch & torch volts

Postby djreiswig » Sun Aug 27, 2017 2:55 pm

I installed the FeatherTouch ohmic sensor on my table and now my torch volts don't go to zero when I'm not cutting. It fluctuates from 0 to 1 or 2 volts while it is sitting. If I disconnect the wire from the shield it will go to zero and stay there. I don't think it is affecting anything as far as cutting goes, I just think it is weird. Is the cutter getting feedback from the ohmic voltage and causing this? Is there something I need to re-calibrate?
2014 Bulltear (StarLab) 4x8
C&CNC EtherCut
Mach3, SheetCam, Draftsight
Hypertherm PM65
Oxy/Acetylene Flame Torch
Pneumatic Plate Marker, Ohmic, 10 inch Rotary Chuck (in progress)

Return to “CandCNC”

Who is online

Users browsing this forum: No registered users and 2 guests

Easyscriber engrave attachment for Hypertherm torch's