AXBB-E and MiniTHC

CandCNC plasma table components discussion forum
Post Reply
Mr.Hotwire
1.5 Star Member
1.5 Star Member
Posts: 47
Joined: Mon Jun 07, 2021 10:49 am

AXBB-E and MiniTHC

Post by Mr.Hotwire »

Im nearing the END of my build, I am utilizing an AXBB-E and a MiniTHC. In the MiniTHC manual it says to interface directly with the AXBB-E. I imagine I will need the port 3 BOB to plug the LPT port into or at least for the break out.

Any suggestions and guidance on this would be GREATLY appreciated. :-D
robertspark
4.5 Star Elite Contributing Member
4.5 Star Elite Contributing Member
Posts: 1801
Joined: Mon Jun 12, 2017 6:43 pm

Re: AXBB-E and MiniTHC

Post by robertspark »

this is in the wrong section CandCNC

useport 3

get an idc 26pin ribbon cable to db25 (I cannot remember if it needs to be an M / F db25.... check!)

then setup the ports and pins as the minithc manual
Mr.Hotwire
1.5 Star Member
1.5 Star Member
Posts: 47
Joined: Mon Jun 07, 2021 10:49 am

Re: AXBB-E and MiniTHC

Post by Mr.Hotwire »

OOF! Sorry... My bad.
Post Reply

Return to “CandCNC Forum”