Valtage divider

JD Squared plasma table discussion forum
Post Reply
Posts: 16
Joined: Fri Sep 20, 2013 12:17 pm

Valtage divider

Post by hanix » Thu Aug 17, 2017 11:02 am

I am little confused
I have Powermax 85 What, should I set the voltage divider to 20:1 21:1 30:1 40:1 or 50:1 when conetitng to mad controller.

User avatar
Posts: 46
Joined: Sun Sep 18, 2016 7:43 pm
Location: Johnson City, TN

Re: Valtage divider

Post by JDSquaredInc » Thu Aug 17, 2017 2:17 pm

The voltage divider should be set to 50:1. Here is a link to our support page that explains hooking that up: ... lasma-unit

Also this site will be good to use for operation of the table.
Ryan Miles - Sales & Marketing
JD Squared, Inc.
Phone: (423) 979-0309

Elite Contributing Member
Elite Contributing Member
Posts: 3028
Joined: Mon Jul 20, 2009 11:18 pm
Location: New Hampshire

Re: Valtage divider

Post by jimcolt » Mon Sep 04, 2017 8:35 am

The default settings on Powermax units that are factory equipped with the CPC/voltage divider option are all preset at 50:1. The instructions to change settings are in the operators manual in the machine torch setup section. Good Choice with the JD Squared system! Jim Colt Hypertherm

Post Reply

Return to “JD Squared”

Easyscriber engrave attachment for Hypertherm plasma cutters.