It is currently Mon Oct 22, 2018 6:14 am

 

THC GOES UP, NOT DOWN?

LDR plasma table discussion forum
Doc Hollywood
Posts: 148
Joined: Fri Jun 28, 2013 4:36 pm

THC GOES UP, NOT DOWN?

Postby Doc Hollywood » Sun Apr 30, 2017 1:58 pm

HI Guys,
Tried searching this, i think it's been covered but i cannot find the answer....
Cutting 16ga art file, material starts to warp, (i usually do not have any material warping btw) and thc brings torch up as it warps. (cool) When torch travels over non-warped up area THC does not lower torch back to correct cut height. Just keeps climbing, as does measured voltage.
What am i missing here? Thanks!
Doc

tcaudle
Posts: 1038
Joined: Tue Feb 28, 2012 6:47 pm

Re: THC GOES UP, NOT DOWN?

Postby tcaudle » Sun Apr 30, 2017 3:44 pm

Turn off TIp Saver. Its locking the torch . The rest of the answer depends on the model of the LDR setup you have. Give Dan a call they are really good at soriting out cutting problems on their equipment.

Doc Hollywood
Posts: 148
Joined: Fri Jun 28, 2013 4:36 pm

Re: THC GOES UP, NOT DOWN?

Postby Doc Hollywood » Sun Apr 30, 2017 5:58 pm

Thanks Tom! I'll call him Monday :-)


Return to “LDR Motion Systems”

Who is online

Users browsing this forum: No registered users and 1 guest

Easyscriber engrave attachment for Hypertherm torch's