Easyscriber engrave attachment for Hypertherm torch's
 

Support

Star-Lab plasma table discussion forum
Post Reply
User avatar
Desertdog
Posts: 25
Joined: Sat Sep 26, 2015 9:50 am
Location: Arizona

Support

Post by Desertdog » Wed Jan 03, 2018 2:12 pm

Matt,

I left you a phone message and sent you an email back on 12/28 that I needed help with some issues. Would you like me to elaborate on the forum or would you rather call me back?
Westcott Retro 5x10
Design2Cut software, CAD, CAM, CUT, all in one program.
Hypertherm 45XP
Champion 2 stage compressor, 7.5 HP motor, 15 HP pump (QUIET!),
80 gallon tank, auto tank drain, mag starter, after cooler.
25.8 [email protected]
Top
BTA Plasma
Elite Contributing Member
Elite Contributing Member
Posts: 485
Joined: Thu May 12, 2011 4:28 pm
Contact:
Contact BTA Plasma

Re: Support

Post by BTA Plasma » Wed Jan 03, 2018 4:56 pm

Your best support is direct support 1-855-433-3689
Top
Post Reply

Return to “Star-Lab”

Who is online

Users browsing this forum: No registered users and 1 guest