Request for information about building a THC controller

Share and learn with other DIY members who have built their own plasma tables and accessories.
Post Reply
enddccc
1/2 Star Member
1/2 Star Member
Posts: 5
Joined: Sat Feb 18, 2023 7:31 pm

Request for information about building a THC controller

Post by enddccc »

Hi,
I'm new to this field and I need some information as I'm building a THC controller for a plasma with contact ignition. Can you tell me what the maximum voltage and frequency are? Also, does anyone have any voltage peak readings on an oscilloscope that I could use to observe the waveform and ripples?
robertspark
4.5 Star Elite Contributing Member
4.5 Star Elite Contributing Member
Posts: 1809
Joined: Mon Jun 12, 2017 6:43 pm

Re: Request for information about building a THC controller

Post by robertspark »

enddccc
1/2 Star Member
1/2 Star Member
Posts: 5
Joined: Sat Feb 18, 2023 7:31 pm

Re: Request for information about building a THC controller

Post by enddccc »

robertspark wrote: Sun Feb 19, 2023 1:43 am viewtopic.php?f=3&t=35154#p222381
Hi,
Thank you for the information. Until now, I have been more focused on continuing with Mach3. Are there any benefits of using LinuxCNC over Mach3?
and to be honest, I'm finding myself in Mach3 more.

Thankss
robertspark
4.5 Star Elite Contributing Member
4.5 Star Elite Contributing Member
Posts: 1809
Joined: Mon Jun 12, 2017 6:43 pm

Re: Request for information about building a THC controller

Post by robertspark »

there are a lot of benefits to linuxcnc but use whatever you are happiest with and works for you.
enddccc
1/2 Star Member
1/2 Star Member
Posts: 5
Joined: Sat Feb 18, 2023 7:31 pm

Re: Request for information about building a THC controller

Post by enddccc »

Hi,
Thanks for the info.

End.
Post Reply

Return to “DIY Plasma Table & Accessory Discussion Forum”