Thermal Dynamics iCNC System

[HARJO]

IMG_0125.jpg (84.73 KiB) Viewed 3336 times

Back on the market... I'd had multiple buyers in the past who have all backed out. Upgrading or building a new table isn't in my immediate need any longer. Invoice total was $19,389.20. Make a reasonable offer. Shipping costs are the responsibility of the buyer, located in 83647. Pic uploads keep erroring out, working on getting them posted.


All Brand New:
iCNC Controller w/internal torch height control
Three NEMA34 motors
Three NEMA34 1:10 gearboxes
75v Power supply for motors
24v Power supply, 6.7amp w/cable for controller
i/o and motor pcb
iCNC Office software bundle, Level 1 & 2, MicroCAD, cost calculator, feedrate module
50' motor cables
100' ohmic cable
Various ground wires
Motor Power Cables

[Pspider Support]

Reduce your image size to 1Mb or less and they should upload just fine.

[cutnweld]

Just curious what route you took instead of utilizing this package? I am currently running Linux and like it, but like to see other controllers etc and there strong points

[HARJO]

Just curious what route you took instead of utilizing this package? I am currently running Linux and like it, but like to see other controllers etc and there strong points

I have a homebuilt table that I built many years ago from an ebay kit that works just fine for my use in the shop. My business isn't centered around plasma CNC, moreso tube fabrication for motorsports. I really only use my current table to make one-off tabs and plates for what I do, and I don't really have a desire anymore to chase plasma cutting as a primary focus of the business.

[HARJO]

Someone in the PM's asked me to post some of the motor specs:

Teknic model CPM-SDSK-3432P-RLN
NEMA34 frame
698oz-in peak torque
2,380 RPM

Neugart PLPE090 10:1 planetary gearboxes for mating to NEMA34