![Smile :)](./images/smilies/icon_e_smile.gif)
I also attached the DXF file I have so far after tracing.
PM Sent. Check your private messages.Splinters&Sparx wrote: ↑Fri Oct 13, 2023 9:12 am I am going crazy trying to figure out how to design this image to cut. I use Aspire, I have traced it, converted it to DXF, but when I look at it to fix lines and areas to keep or fall out I am at a loss. I haven't been doing this long so I appreciate any tips I can get. I will pay someone to teach me this, I am desperate. The sign is supposed to be 24" H after its cut. Thank ya'll in advance.
I also attached the DXF file I have so far after tracing.
A design with multiple colors cannot easily be cut out if a single layer of media. It is possible, but you are talking about a LOT of custom drawing time to make puzzle pieces, each individually cut out and taking kerf width and other factors into consideration.Splinters&Sparx wrote: ↑Fri Oct 13, 2023 9:12 am I am going crazy trying to figure out how to design this image to cut.
This image has 16 different colors. It is not well suited for plasma cutting. You could use a router for solid material, but this image is better suited for a vinyl cutter or a printed process.Splinters&Sparx wrote: ↑Fri Oct 13, 2023 9:12 am I am going crazy trying to figure out how to design this image to cut.