A friend is going to purchase two of these Harbor Freight Greenhouses (10'x12') and we are going to put them together as a single 12'x20' greenhouse. The single 20' roofline will be rotated 90 degrees, and the internal wall panels will be substituted for a lower pitch roof. Eight additional panels will be required to complete the project and thankfully, HFT sells them as "replacement parts."
I am going to use my plasma table to BEEF UP the cheap Chinese design of this thing. I will cut braces and gussets, etc,, to make the assembly both cleaner and stronger. The project is slated for October-ish, depending on the weather,. The inside of these things gets really hot, and fast.
http://www.harborfreight.com/lawn-garde ... 93358.html
Joe
HFT Greenhouse Project
- Joe Jones
- 5 Star Elite Contributing Member
- Posts: 3131
- Joined: Sat Oct 11, 2014 2:33 pm
- Location: Franklin, KY., USA
- Contact:
HFT Greenhouse Project
Franklin, KY., USA
Samson 510 & 4x4
6” Z Rail Lift Kit for PlasmaCam
CreatBot D600 PRO 3D Printer
12 Lasers
FREE DesignEdge Training!
It is more fun when it isn't necessary!
Samson 510 & 4x4
6” Z Rail Lift Kit for PlasmaCam
CreatBot D600 PRO 3D Printer
12 Lasers
FREE DesignEdge Training!
It is more fun when it isn't necessary!
- Joe Jones
- 5 Star Elite Contributing Member
- Posts: 3131
- Joined: Sat Oct 11, 2014 2:33 pm
- Location: Franklin, KY., USA
- Contact:
Re: HFT Greenhouse Project
I drew up both greenhouses and all of the components in DesignEdge. Then I used drag-and-drop, to assemble ONE 12x20 greenhouse from the available components. I almost made it. I only need 8 additional roof trusses and two small front right ceiling plates to complete the project.
I hope Harbor Freight will sell those individual pieces. If not, I will fabricate something to replace them.
Joe
I hope Harbor Freight will sell those individual pieces. If not, I will fabricate something to replace them.
Joe
Franklin, KY., USA
Samson 510 & 4x4
6” Z Rail Lift Kit for PlasmaCam
CreatBot D600 PRO 3D Printer
12 Lasers
FREE DesignEdge Training!
It is more fun when it isn't necessary!
Samson 510 & 4x4
6” Z Rail Lift Kit for PlasmaCam
CreatBot D600 PRO 3D Printer
12 Lasers
FREE DesignEdge Training!
It is more fun when it isn't necessary!
- Joe Jones
- 5 Star Elite Contributing Member
- Posts: 3131
- Joined: Sat Oct 11, 2014 2:33 pm
- Location: Franklin, KY., USA
- Contact:
Re: HFT Greenhouse Project
They DO sell the individual components! I think I will make a video of this process, so other people can figure out how to combine two of them as well.
Joe
Joe
Franklin, KY., USA
Samson 510 & 4x4
6” Z Rail Lift Kit for PlasmaCam
CreatBot D600 PRO 3D Printer
12 Lasers
FREE DesignEdge Training!
It is more fun when it isn't necessary!
Samson 510 & 4x4
6” Z Rail Lift Kit for PlasmaCam
CreatBot D600 PRO 3D Printer
12 Lasers
FREE DesignEdge Training!
It is more fun when it isn't necessary!