I have 4 sheets of 5086 1/2 thick aluminum, 48 x 144. I need about 350 inches of cut on each sheet and about 16 pierces. I am not real concerned with edge quality, I can clean up with a router. Would just as soon give money to one of you guys.
PM me if interested will, know this week if I get the job.
Thanks
Jim
Washington State Table Owners
-
- 2 Star Member
- Posts: 56
- Joined: Wed Sep 26, 2012 5:42 pm
- Location: Maple Valley, WA
-
- 3.5 Star Elite Contributing Member
- Posts: 689
- Joined: Fri Aug 15, 2008 6:22 pm
- Location: Tenino,WA
Re: Washington State Table Owners
Hope you get the job Jim. My 1250 hasn't got the umph to do it or I'd say come on down. But you can come on down and visit anyway
plain ol Bill
Hypertherm 1250
Duramax machine torch
Corel Draw X6
Sheetcam
Mach3
5 x 10 self built table
Lots of ineptitude
Hypertherm 1250
Duramax machine torch
Corel Draw X6
Sheetcam
Mach3
5 x 10 self built table
Lots of ineptitude
-
- 3 Star Member
- Posts: 395
- Joined: Sun Jan 02, 2011 11:03 pm
Re: Washington State Table Owners
Really? I'm surprised to hear that--I looked at the 1250 manuals, they say 37 IPM cut speed at 80A on 1/2" AL....seems fairly reasonable to me.plain ol Bill wrote:Hope you get the job Jim. My 1250 hasn't got the umph to do it or I'd say come on down. But you can come on down and visit anyway
But then again, I'm just assuming....I have a Powermax 45, which wouldn't do the job too well I'm sure.
-
- 4 Star Member
- Posts: 1402
- Joined: Mon Aug 30, 2010 5:56 am
- Location: Palm Bch Gardens Fl
- Contact:
Re: Washington State Table Owners
YOU CAN DOOOOO IT BILL!!!!!!!!!
1250 hypertherm
4 X 8 Precision Plasma
CandCnC electronics
4 X 8 Precision Plasma
CandCnC electronics
-
- 3.5 Star Elite Contributing Member
- Posts: 689
- Joined: Fri Aug 15, 2008 6:22 pm
- Location: Tenino,WA
Re: Washington State Table Owners
My 1250 is very capable of doing the job. However - (always a however isn't there) my electrical circuit is not up to it. I can, and have cut small jobs using 1/2" but pushing it for any length of time trips the breaker. Sure wish I could Jim. Give Mikey a call.
plain ol Bill
Hypertherm 1250
Duramax machine torch
Corel Draw X6
Sheetcam
Mach3
5 x 10 self built table
Lots of ineptitude
Hypertherm 1250
Duramax machine torch
Corel Draw X6
Sheetcam
Mach3
5 x 10 self built table
Lots of ineptitude
-
- 2 Star Member
- Posts: 56
- Joined: Wed Sep 26, 2012 5:42 pm
- Location: Maple Valley, WA
Re: Washington State Table Owners
Mike, is going to graciously help me out and I can help him out, perfect deal for us both!!! Thanks to all of you guys for your comments and good wishes. My son and I are hoping to get our table sometime this next year. But have to eat first!
Thanks Guys, Have a great Christmas!
Jim
Thanks Guys, Have a great Christmas!
Jim